RESET
RESET
TEST
TEST
6
T105 IB
April 11,08
152mmw x 152mm H
Color: Black
3
Quick start
Slide open the battery compartment on the bottom
of the unit. Attach AC adaptor cable inside battery
compartment on the bottom of T105 and plug the
other end into a wall socket.
2: clock battery backup
Insert 1 “CR2032” battery as indicated into battery
compartment. Replace battery compartment cover.
Using the Alarm
Snooze Operation
1. After setting the alarm time, set the Alarm Switch located on the back of the unit to ON to turn on the alarm. The Alarm
Indicator Icon will appear on the display, showing that the alarm will sound at the time displayed.
2. After the alarm sounds, press the Alarm Set/Reset Button to turn off the buzzer and automatically reset the alarm for
the same time the following day.
3. To turn off the alarm without setting it for the following day, switch the Alarm Switch to OFF. The Alarm Indicator Icon
will disappear.
NOTE: The alarm will sound for approximately 1 hour and then turn off automatically. This cycle will repeat every 24 hours unless
the controls are changed.
1.
Press down anywhere on top of the clock cabinet after the alarm sounds to temporarily shut off the alarm, allowing you to
snooze for nine minutes before the alarm sounds again. You may repeat this several times during the one-hour alarm cycle
.
Color Change
1. During normal mode, press anywhere on top of the clock cabinet to change the color of cabinet and display backlight.
Each time you press, the light color changes (there are 7 colors).
2. You can control the backlight brightness by setting the Dimmer Switch to Hi, Med or Lo.
1: power
Press and hold the Alarm Set/Reset Button on
the back of the T105 until the alarm time display
flashes. Press the Hour Button to advance the
hour (a PM indicator appears for PM setting; there
is no AM indicator), then press the Minute Button
to advance the minutes. When the correct alarm
time is set, press the Alarm Set Button. Two
beeps will confirm alarm setting is complete. Move
the Alarm Switch on the back of the unit to the ON
position to arm the alarm. The alarm indicator will
appear.
4: alarm setting
Press and hold the Time Button on the back of the
T105 until the time display flashes. Press the Hour
Button to advance the hour (a PM indicator
appears for PM setting; there is no AM indicator),
then press the Minute Button to advance the
minutes. When the correct time is set, press the
Time Button. Two beeps will confirm clock setting
is complete.
3: clock setting
(2 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals